Wacker Neuson 0008429 series Operator's Manual - Description
Description
T00755GB.fm
11
4.4.2
Crankcase
Access to rotor circlip: Remove screws, take bearing cover and crank
mechanism out of crankcase.
4.4.3
Disassembly of handle
Remove screws. Remove handle half and back handle.
4.4.4
Motor
Access to stator pack and rotor: Remove screws, remove bearing
bracket from crankcase. Remove stator pack. Then pull out O-ring and
air guiding bushing. Remove circlip and force out rotor.
4.5
Assembly
For assembly proceed in the reverse order to dismantling. The
following has to be observed in particular:
∗
All parts must be carefully cleaned and checked. Grease bearings,
crank mechanism and percussion system with special grease (see
technicla data).
∗
Clean front surfaces of cylinder housing and crankcase and seal with
Omni Visc, model 1002.
∗
Use Omnifit 230L to glue outer race of deep groove ball bearing.
∗
After completion of any kind of repairs, test-run with increasing load.