Wacker Neuson 0008429 series Operator's Manual - Maintenance
Maintenance
T00757GB.fm
12
5.
Maintenance
5.1
Maintenance schedule
5.2
Maintenance and lubrication
5.2.1
General instructions
Keep hammer and tools clean.
5.2.2
Mechanical part
∗
Every 20 hours of operation moderately grease crank mechanism and
percussion system via lubricating nipple situated on crankcase. Use
special grease (see technicla data).
∗
Check tool holder brushing for wear. The tool may have a play of max.
6 mm at a distance of approx. 200 mm from the entrance. If the
bushing is worn to a greater degree, replace it to avoid damages and
operational failures.
Component
Maintenance work
Maintenance
interval
Feed line
Check for perfect condition - if cable defective,
replace.
daily
Miscellaneous
Fan slits dirt - free - clean if necessary.
Tools
Check the shafts and cutting edges -
ifnecessary, sharpen, reforge or replace.
Miscellaneous
Regrease via grease nipples.
20 hours
Tool holder
Check for wear - change if necessary.
monthly
Miscellaneous
Regrease crankshaft drive.
600 hours