Wacker Neuson BTS 1030 Operator's Manual - page 28
T00823GB
26
Refuelling
IMPORTANT:
FOLLOW
THE
SAFETY
PRECAUTIONS BY ALL MEANS!
Be careful and cautious when handling fuels.
The engine must be turned off and cooled down!
Carefully clean the area around the fuel-tank filler neck
to keep dirt from getting in the tank.
Place the unit on its side on an aven surface.
Unscrew the tank cap and fill tank with fuel mixture.
Take care to avoid spilling.
Tightly screw on the plug.
Clean screw plug and tank after refuelling. Never
start or operate the Power Cut in the same place as
it was fuelled!
Starting the engine
This model features a semiautomatic starting valve (1)
(Happy-Start) to make starting easier. Pushing this
valve in reduces the amount of compression effort
needed, so that it is easier to bring the engine up to
starting speed when pulling the starter cable.
The high pressure increase in the combustion
chamber that results from the first ignitions will
automatically close the starting valve (button pops
back out).
CAUTION:
Observe the SAFETY INSTRUCTIONS!
Start the Power Cut only after complete assembly
and inspection!
Move at least 3 m away from the place where you
fuelled the Power Cut.
Make sure you have a good footing, and place the
Power Cut on the ground in such a way that the
cutting disc is not touching anything.
Fuel mixture
38
39
necessary
if
3 meters
40