Wacker Neuson BTS 1030 Operator's Manual - page 30
T00823GB
28
Turn the hood lock (2) to position
and hold it there.
Pivot the hood (3) back as far as it will go.
Release the hood lock and pivot the hood lightly back
and forth until the lock engages.
Cold-starting
Move the combination switch (5) up (choke position).
Grasp handle (hand pressure actuates the grip throttle
lever lock (7)).
Push the throttle (8) in all the way and hold it.
Press the throttle lock (6) and release the throttle (8)
(the throttle lock will hold the throttle at half-throttle
position). Push the starting valve (4).
Grasp the tubular handle firmly with one hand and
press the Power Cut against the ground:
Place the tip of your left foot in the rear handle.
Slowly pull out the starter cable until you notice
resistance (the piston is positioned before the top
dead centre).
Now pull the starter cable with a fast and forceful
movement until you hear the first ignition.
Caution: Do not pull out the starter cable more than
approx. 50 cm, and lead it back by hand.
Press in the starting valve (42/4) in again.
Put the combination switch (42/5) in position “I“.
Keep pulling the starter cable until the engine catches.
As soon as the engine is running, press the throttle
(42/8) to release the half-throttle lock (42/6), allowing
the engine to idle.
Warm-starting
As described under „Cold starting“, except without
putting the combination switch (42/5) in choke
position.
41
42
43