Wacker Neuson DPU 5045H Operator's Manual - page 15
T00555GB
13
OPERATION
Starting
Conditions:
Oil:
Check oil level on oil dipstick (21), if necessary top up with Fuchs Titan Unic 10W40 MC using the
filler nozzle (19).
Fuel:
When pouring diesel fuel into the fuel nozzle (20), maintain absolute cleanliness. Impurities in the
fuel can cause breakdowns in the injection system and premature clogging of the fuel filter.
Air filter:
Clean air filter dry, dusty conditions.
Once these points have been observed, you can start the engine as follows:
1. Turn the throttle control lever (8) clockwise into full load position.
2. In extreme cold also activate the automatic decompression (2).
3. Turn ignition switch key (22) to operating position; then push in starter button and hold until engine is run-
ning.
☛
ATTENTION!
Wait until the engine stops before repeating the starting procedure.
4. Turn throttle control lever (8) into idling position, allow engine to warm up for 7 minutes at idling speed.
Note: Do not activate automatic decompression lever while the engine is running.
Forward and reverse motion
The engine speed can be infinitely varied on the throttle control lever (8).
The direction of travel is determinet with the shift lever (6).
Depending on the position of the shift lever (6), the vibration plate compacts in forward direction, at standstill
or in reverse direction.
The forward and reverse speeds can be varied by selecting intermediate positions of the shift lever (6) or the
machine can be employed for particularly intensive compaction at standstill.
Forwards
Standstill
Reverse