Wacker Neuson EH 6 Operator's Manual - page 41
Other manuals for EH 6:
Operator's Manual
Manual is about: Electric hammer
of
62
EH 6, EHB 7
8 Operation
41
8.3
Changing tools
Safety instructions
You can change the tool without additional tools.
Notes on using tools
Only use tools with the following properties:
The tool end must be undamaged.
The tool must be sufficiently sharp to avoid impact damage.
The tool must be suitable for the intended application.
Inserting tool
1. Clean tool end.
2. Grease tool end.
3. Insert tool into tool holder.
4. Turn tool and press into holder until automatically locked into place.
5. Check to see if the tool is locked by pulling on the tool.
Item
Designation
1
Tool
2
Tool holder