Wadia a102 Owner's Manual - page 13
13
Input Mode Switch
The Input Mode Switch, which is located on the Rear
Panel of the a102, allows selection of
either the BALanced or UNBALanced
Inputs. Refer to figure 9.
Power On/Off
Momentarily press the POWER Push-button to switch
the a102 On or Off. Refer to figure 7.
Note: There must be a Trigger Control
Connection between the a102 and
the Audio Preamplifier or Source
Device, in order for the remote
power turn-on to function.
Auto Off
The a102 incorporates a Power Save Feature to
automatically switch power Off to the Power Ampli-
fier approximately 30 minutes after there has been an
absence of an audio input signal.
Note: If the Power Save Feature has activated and
switched the a102 Off, the Power Save Fea-
ture can be reset by momentarily pressing the
STANDBY/ON Push-button.
When there is a Trigger Control Connection be-
tween the a102 and a Preamplifier or Source Device,
the Power Save Feature in the a102 is bypassed.
With the a102 connected (via Trigger Control) to
a Preamplifier (Source Device) with the Power Save
Feature and the feature is active, the a102 will switch
Off with the Preamplifier (Source Device) after a
period of inactivity.
There may be times when it would be desirable to
bypass the Power Save Feature, which by default is ac-
tive. This can be implemented by placing the “AUTO
OFF” Switch, located on the a102 Rear
Panel, in the DIS (Disable) position.
Refer to figure 8.
How to Operate
How to Operate
Figure 7
Figure 8
Figure 9