Wadia a102 Owner's Manual - page 9
9
Connectioning to a Preamplifier
The connection instructions below with the diagram
to the right is an example of a typical audio system.
Your system may vary from this, however the actual
components would be connected in a similar manner.
For additional information refer to “Connector and
Cable Information” on page 4.
1. For remote AC Power control of the a102, connect
a control cable from the Audio Preamplifier or
Source Device Trigger Out to the a102 TRIGGER
IN.
Note: When a Triger Control Cable is connected
between the a102 and Preamplifier/Source
Device, the AUTO OFF Feature is bypassed.
Refer to page 13.
2. Connect XLR cables from the Balanced Output
(L&R) of an Audio Preamplifier/Source Device
to the a102 BALanced INPUTS (Right and Left).
Note: An optional hookup is to use an unbalanced
cable(s) and place the INPUT MODE Switch
in the UNBALanced Position.
3. Proceed to “Output Terminals and How to con-
nect” on page 10.
Connectioning to a Preamplifier
Preamplifier