WAGNER AG-14 Owner's Manual - Residualrisks
AG-14 11
GB
conditions exist. Never repair a paint hose. Replace it with another grounded high-
pressure hose.
• Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has been removed
and a high pressure has been set on the airless high-pressure pump. Therefore, when
cleaning without tip set the pressure control valve to the lowest pressure.
• Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specifications and safety devices of the spray gun
manufacturer.
EXPLOSIONPROTECTIONIDENTIFICATION
Xmarking:
ThesprayguncorrespondswithExII2GXandis,inaccordancewithDirective94/9/EEC
(Atex100a),suitableforuseinexplosion-hazardousareas—asoftypeZone1.Under
certaincircumstances,theunititselfmaycausetheZone1conditiontobeineffect.
Anystatic-electricitydischargefromthespraygunistobedivertedtothegroundedhigh-
pressurepumpviatheconductivehigh-pressurehoseasstipulated.
Themaximumsurfacetemperaturecorrespondstothepermissiblematerialtemperature.
ThisandthepermissibleambienttemperaturecanbefoundintheTechnicalData.
To avoid the generation of machine sparks, prevent impact stresses and any work on the unit
with tools in the explosion-hazardous area.
Residualrisks
Residual risks are risks, which cannot be excluded, even when equipment is used for the
intended purpose.
In such cases the applicable areas of the actual residual risks will be pointed out using warning
and/or prohibition signs.
Risk
Source/Cause
Impact
Preventativemeasures
Canoccur
during:
Injection
injury
Atomized, high
pressure stream of
fluid
Severe
injury or
amputation
NEVER aim the gun at
any part of the body
Setup,
Operation
Explosion or
fire
Static electricity or
sparks
Severe
injury
Use well ventilated area
Ground the spray gun
Operation
Hazardous
vapors
Hazardous vapors
from spray material
Severe
injury
Use well ventilated area
Use mask
Operation
TechnicalData
Max.operatingpressure
27 MPa (3900 PSI)
Materialinletthreadsize
M16 x 1.5 (NPSM 1/4”)
Diffuserthreadsize
7/8 - 14 UN-2A
11/16 - 16 UN-2A
Wettedpartsmaterial
High-grade stainless steel, urethane, polyethylene,
nylon, hard metal
Operatingtemperaturerange
5ºC to 40ºC (40ºF to 104ºF)
Maximummaterialtemperature
43ºC (109ºF)
Maximumsoundoutput
81 dB(A)*
Weight
590 g (1,3 lb.)
* Measurement location: 0.5 m away from the coating surface, 0.5 m behind the spray gun,
spray pressure 12 MPa, tip size 0.021