1. DL manuals
  2. WAGNER
  3. Paint Sprayer
  4. Control Stainer 150
  5. Owner's Manual

WAGNER Control Stainer 150 Owner's Manual

Manual is about: Handheld Sprayer

Summary of Control Stainer 150

  • Page 1

    0117 • form no. 0529650b control stainer ™ 150 owner‘s manual read this manual for complete instructions franÇais - p. 13 espaÑol - p. 25 wagner-group.Com watch a video manual at www.Wagnerspraytech.Com/controlstainer150 en es f.

  • Page 2

    2 en important safety information table of contents important safety information ............................................. 2-3 controls and functions ........................................................... 4-5 setup ...............................................................................

  • Page 3

    En 3 important safety information safety hazards hazard: explosion or fire flammable vapors, such as solvent and paint vapors, in work area can ignite or explode. Prevention: • do not spray flammable or combustible materials near an open flame, pilot lights or sources of ignition such as hot objects...

  • Page 4: Controls And Functions

    4 en controls and functions material flow control kickstand trigger pickup tube material container (600 ml) filter housing on/off switch turbine air cap nozzle nut seal nozzle assembly filter seal.

  • Page 5: Controls And Functions

    En 5 controls and functions 0 on / off switch the on/ off switch turns the turbine on (i) and off (0). No spray material will be delivered until trigger is pulled. Material flow control the material flow control knob determines the amount of spray material that is sprayed from the spray nozzle. Trig...

  • Page 6: Setup

    Setup 6 en material preparation i material to be sprayed may need to be strained to remove any impurities in the paint which may enter and clog the system. Impurities in the paint will give poor performance and a poor finish. I latex paints and primers are not recommended to be used with this spraye...

  • Page 7: Setup

    En 7 setup 1 2 3 a b 4 5 6 assembly never point the spray gun at any part of the body. Make sure the power cord is unplugged. 1. Stir the spraying material thoroughly. 2. Fill the container. Use a strainer to remove any particles. (see thinning the material, previous page, if thinning is required). ...

  • Page 8: Sprayer Controls

    8 en sprayer controls air cap ears 1 = = = = = = 2 = = = = = = 3 = = = = = = material flow control i the material flow control will be factory-set at its lowest setting out of the box. Adjust as needed. • turn the knob out (counterclockwise) for less flow. Generally, low material flow is needed for ...

  • Page 9: Spraying

    En 9 spraying how to spray properly • turn the on/off switch to on (i) to turn on the turbine. No material will spray until the trigger is activated. • position the spray gun perpendicular to the spray surface. • spray parallel to the surface with straight and full passes at a consistent speed as il...

  • Page 10: Cleanup

    10 en cleanup 1 2 3 (a) 4 (b) (c) 5 groove tab notch cleanup notes i when cleaning, use the appropriate cleaning solution (warm, soapy water for water-based coatings, and mineral spirits for oil-based coatings. Special cleanup instructions for use with flammable solvents (must have a flashpoint abov...

  • Page 11: Maintenance

    En 11 maintenance cleaning the filter important: before every use, you should inspect the air filter in the turbine to see if it is excessively dirty. If it is dirty, follow these steps to replace it. Never operate your unit without the air filters. Dirt could be sucked in and interfere with the fun...

  • Page 12: Troubleshooting

    Troubleshooting 12 en problem cause solution problem a: little or no material flow 1. Nozzle clogged. 2. Suction tube clogged. 3. Material flow setting too low. 4. Suction tube loose. 5. No pressure build up in container. 6. Air filter clogged. 7. Spray material too thick. 8. Nozzle seal missing or ...

  • Page 13: Es F En

    37 parts list • liste de pièces • lista de piezas es f en 1 2 3 # part no. Nº de piéce pieza no. English description français description español descripción qty. Qte. Cant. 1 ------- turbine (includes item 2-3) turbine (inclut de pièce 2-3) turbina (incluye le articulo 2-3) 1 2 2307279 filter filtr...

  • Page 14: En F Es

    38 en f es parts list • liste de pièces • lista de piezas # part no. Nº de piéce pieza no. English description français description español descripción qty. Qte. Cant. 1 0529276 nozzle assembly (includes items 1-9) ensemble de buse (inclut des pièces 1 à 9) ensamblaje de boquilla (incluye los articu...

  • Page 15: Es F En

    39 limited warranty • garantie limitée • garantía limitada es f en hvlp paint spray equipment this product, manufactured by wagner spray tech corporation (wagner), is warranted against defects in material and work-manship for one year following date of purchase if operated in accordance with wagner’...

  • Page 16: Control Stainer

    Control stainer ™ 150 wagner-group.Com.