WAGNER PAINTMATE PLUS Manual - page 3
The Painting People
™
© 2001 Wagner Spray Tech. All rights reserved.
3
English
PRIMING THE ROLLER
QUICK PRIMING METHOD
1. Leave switch on FILL and push plunger tube forward until
you see paint coming through the roller cover.
2. Once paint appears, flip switch to APPLY and begin rolling.
Squeeze Power Trigger
®
for additional paint as needed.
OPTIONAL PRIMING METHOD
1. Move switch to APPLY, then squeeze the trigger on the
main tube. It will take several squeezes of the trigger to
fully saturate the roller cover.
APPLYING PAINT
Because priming the roller may use a lot of the paint in the main
tube, you may need to refill the main tube after priming. Once
paint appears through the roller cover, begin rolling. Keep paint
flowing to the roller by squeezing the trigger as necessary.
Refill as necessary to complete project.
NOTE: When painting, make sure your floors and
furnishings are sufficiently protected against
drips or spatters.
NOTE: When using either method, do not oversaturate
the roller. An oversaturated roller will slide,
drip, and spatter excessively.
FILL
APPLY
FILL
APPLY
FILL
APPLY
GENERAL CLEANUP
RETURNING EXCESS PAINT TO PAINT CAN
1. Turn the switch on the main tube handle to FILL.
2. Pull plunger back to draw remaining paint from roller arm
into tube.
3. Press fill valve of main tube onto fill tube.
4. Push plunger forward to return excess paint to can.
CLEANING THE ROLLER ASSEMBLY
1. Remove spatter shield. Press locking tab and remove roller
cover assembly from arm.
2. Insert thumb to first knuckle, PRY and PULL the cap from
the roller cover. Once the cap is removed, PUSH the roller
cover out the other end.
3. Place spatter shield, roller cover, cap and core in a bucket
with the appropriate cleaning solution.
NOTE: Make sure your floors and furnishings are
protected from dripping paint when removing
or disassembling the roller assembly.
Locking
tab
1
2
3
4
FILL
APPLY
NOTE: These steps can be followed when using oil-
based and latex paints.