WAGNER ROMAXENON Manual - Operating Instructions
GB
5
Operating instructions
Congratulations on the purchase of your
WAGNER
ROMA SENSOR. Read the operating
instructions carefully before using the equipment and observe the safety instructions. Keep
the operating instructions in a safe place.
NOTE: The ROMA SENSOR is weather-proof and should be used in direct
sunlight. Install the ROMA SENSOR in such a way that the solar module is
exposed to as much sunlight as possible in order to ensure maximum
efficiency
.
The ROMA SENSOR is equipped with an NiCd rechargeable battery. This battery is
supplied uncharged. Before using for the first time, charge the battery for two days
in direct sunlight in order to achieve maximum power. For this first charging, the
main switch must be set to „0“
.
INSTALLATION
• Choose a site for installation with as much irradiation as possible. Do not place the
ROMA SENSOR in the shade of trees, bushes or buildings, as this will greatly reduce
the degree of efficiency of the ROMA SENSOR
.
• Install your ROMA SENSOR in such a way that people will cross the infra-red
sensor's field of coverage at as close to a right angle as possible. Where possible,
avoid an approach directly towards the sensor, as movement in this direction will not
register. The sensor's coverage angle is approx. 60°. Dependent upon the ROMA
SENSOR'S alignment, the sensor's range can be up to 6 m. In order to make optimal
use of the coverage area (60°), the ROMA SENSOR should be mounted a minimum
of 1 m away from the walkway
.
Technical data ROMA SENSOR Xenon Vario
Solar panel
amorphous silicon technology
Size
approx. 122 x 115 mm²
Output with full irradiation
approx. 750 mW
Rechargeable battery
NiCd
Voltage
4,8 V
Charging capacity
700 mAh
Lamp element
XENON lamp 4,5 V
Power input
5 W
Lux (distance approx. 30 cm)
60 lx
Light duration
max. 50 x 45 sec./max. 40 x 45 sec.
Sensor coverage angle
approx. 60°
Sensor range
approx. 6 m