Wahlberg 241 User Manual - Winch 10 - Cheat Sheet
27
805.241.011
Date: March 22
rd
, 2017
How to get started
1.
Place / Rig the winch in something high with minimum 2-3 meter below.
2.
Put on counterweight on the winch hock, minimum 1 kilo.
3.
Set the DMX start address to 001, and the MODE to 2.
4.
Apply DMX from a Lighting desk, best is a desk with manual faders.
5.
Make sure that your 7 channels are patched from DMX channel 1 to 7.
6.
Pull all channels on to 0%
7.
Apply power to the winch.
DMX lamp should be lit, and the mode lamp should be flashing.
8.
Pull channel 6 to 20 % -- the winch starts pulling the wire.
9.
Stop (pull channel 6 to 0%) when the wire is at the top position (pulled into the winch).
NOW the winch has found its TOP position and is ready to drive with position control.
10.
Pull channel 1 (position) to 95 %
11.
Pull channel 3 (speed) to 20%
Now the winch start to move down, with 20% speed, to a position the is 95% up.
12.
Pull channel 1 (position) to 80%
Now the winch starts to move down, with 20% speed, to a position that is 80% up.
13.
Pull channel 1 (position) to 90 %
14.
Pull channel 3 (speed) to 50%
The Winch starts to move UP again, with 50% speed, and stops 1 meter before the top
.
Before each use
Inspect the entire length of the
wire rope
for bends,
damage, wear, cut cord, corrosion and abuse.
Inspect the
wire ferrule crimp
and
thimble
for
damage, wear, corrosion or abuse.
Check all limit switches.
Check the slack detection device
Check the emergency stop (if enabled).
Check that the wire is winded neatly on the drum.
Warning! Do not use the winch if any damage or error is
found!
Inspection
points
Intact wire
Broken wire
Winch 10 - Cheat Sheet
MODE
Functions
DMX
channels
Function
0
Neutral function – motor stops
1
Position rough (Hi of a 16 bit DMX channel)
1
Positioning with auto TOP reset
2
Position fine (Lo of a 16 bit DMX channel)
2
Positioning with manual TOP reset
3
Set the maximum speed
3,4,5,6
Stops the motor unless specified otherwise
4
Set the maximum travel top
7
Manual run up (no DMX needed)
5
Set the maximum travel bottom
8
Manual run down (no DMX needed)
6
Find top position, moving up (reset speed)
9
Used for re-calibrating overload see page 18 7
Moving down