Waldorf IN8200E Installation And Operation Manual - page 10
8
Installation
Assembly
This model is delivered completely assembled. Ensure that the adjustable feet are securely attached.
NOTE:
This appliance is fitted with adjustable feet to enable the appliance to be positioned
securely and level. This should be carried out on completion of the electrical connection.
Rear Roller Kit - For installation details, refer to the instructions supplied with the kit.
Electrical Connection
NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY A QUALIFIED
SERVICE PERSON.
Each appliance should be connected to an adequately protected power supply and isolation switch mounted
adjacent to, but not behind the appliance. This switch must be clearly marked and readily accessible in
case of fire.
1.
Check that the electricity supply is correct as shown on the Rating Plate. Refer to the 'Dimensions
Section’ for rating plate locations for the different model types.
2.
The supply terminal connections are located at the rear of the the appliance. Refer to ‘Electrical
Connections’ in the ‘Specifications’ section of the manual.
3.
Bring the supply cable up through the compression type gland provided on the rear of the main
electrical switchgear panel.
4.
Connect the mains supply to L1, L2 and L3 connections as required. Refer to the 'Electrical Supply
Requirements' section.
5.
Connect earth conductors to earth stud.
6.
For all connections ensure that conductors are secure and appropriately terminated.
7.
Tighten the cable gland to secure against tension on the cable.
NOTE:
This appliance must be earthed.
Fixed wiring installations must incorporate an all-pole disconnection switch.
8.
Correctly locate the appliance into its final operating position and using a spirit level, adjust the legs
so that the appliance is level and at the correct height.
9.
Connect the power supply to the appliance.
10. Check that the electrical supply is as shown in ‘Specifications’ section.
C
AUTION
:
This appliance is for professional use and is only to be used by qualified
persons.
Only qualified service persons are to carry out installation and servicing of
this appliance.
WARNING:
T
HIS
APPLIANCE
MUST
BE
EARTHED
. I
F
THE
SUPPLY
CORD
IS
DAMAGED
,
IT
MUST
BE
REPLACED
BY
A
SUITABLY
QUALIFIED
PERSON
IN
ORDER
TO
AVOID
A
HAZARD
.