Waldorf IN8200E Installation And Operation Manual - page 9

7 

Installation

Installation Requirements 

NOTE: 

 It is most important that this Induction Cooktop is installed correctly and that operation is 

correct before use.  Installation shall comply with local electrical and health and safety 

requirements. 

Waldorf Induction Cooktops are designed to provide years of satisfactory service, and correct installation is 

essential to achieve the best performance, efficiency and trouble-free operation. 

This appliance must be installed in accordance with National installation codes and in addition, in 

accordance with relevant National / Local codes covering gas and fire safety. 

Australia / New Zealand 

AS/NZS 3000 

 - Wiring Rules. 

United Kingdom: 

BS 7671 

 - Requirements for Electrical Installations.

Installations must be carried out by qualified persons only.  Failure to install equipment to the 

relevant codes and manufacturer’s specifications shown in this section will void the  

warranty. 

Components having adjustments protected (e.g. paint sealed) by manufacturer, are only  

to be adjusted by an authorised service agent.  They are not to be adjusted by the installation 

person. 

Unpacking 

 Remove all packaging and transit protection from the appliance including all protective plastic  

coating from the exterior stainless steel panels. 

 Check equipment and parts for damage.  Report any damage immediately to the carrier and 

distributor. 

 Report any deficiencies to the distributor who supplied the appliance. 

 Check that the available electrical supply is correct to that shown on the Rating Plate attached to the 

underside of the R/H side, front Induction Cooktop lower trim. 

Location 

1. 

Installation must include adequate clearance and ventilation. 

2. 

Position the appliance in its approximate working position. 

3. 

The legs must always be fitted.  Ensure that the legs are securely attached. 

Clearances 

NOTE:  Only non-combustible materials can be used in close proximity to this appliance. 

Combustible Surface 

Non Combustible Surface 

Left / Right Hand Side 

50mm 

0mm 

Rear 

50mm 

0mm