Waldorf IN8200E Installation And Operation Manual - page 14

12 

Cleaning and Maintenance

C

AUTION

: 

Always turn off the electrical power supply at the mains supply before cleaning. 

This appliance is not water proof. 

Do not use water jet spray to clean interior or exterior of this appliance. 

General 

Clean the Induction Cooktop regularly.  A clean appliance looks better, will last longer and will  

perform better.  Carbonised grease on the surface will hinder the transfer of heat from the cooking 

surface to the food.  This will result in loss of cooking efficiency. 

DO NOT use water on the induction hob while this item is still hot as warping and 

cracking may occur.  Allow the hob to cool down before cleaning. 

NOTE: 

 DO NOT use abrasive detergents, strong solvents or caustic detergents as they could  

corrode or damage the induction hob. 

To keep your Induction Cooktop clean and operating at peak efficiency, follow the procedures shown 

below:- 

After Each Use 

1. 

Clean the Induction Cooktop hob area with a plastic or wooden scraper tool to remove any food 

debris. 

2. 

Wipe down with a damp cloth lightly moistened with a solution of mild detergent and water.  Dry the 

Cooktop hob area thoroughly with a dry cloth and polish with a soft dry cloth. 

Daily Cleaning 

1. 

Thoroughly clean the splash back, the interior and exterior surfaces of the Induction Cooktop with 

hot water, a detergent solution and a soft scrubbing brush. 

2. 

Clean the Control Panel with a damp cloth lightly moistened with a solution of mild detergent and 

water.  Dry the control panel thoroughly with a dry cloth and polish with a soft dry cloth. 

3. 

Any carbon deposits should be removed using a plastic or wooden scraper tool followed by wiping 

with a cloth moistened in a solution of hot water and detergent to prevent accumulation of food 

deposits. 

4. 

Dry the Induction Cooktop thoroughly with a dry cloth and polish with a soft dry cloth.