Waldorf RN8110G Installation And Operation Manual - page 13
11
Lighting the Pilot Burner - (Oven)
This oven is fitted with a pilot as a standard option and Flame Failure Protection, which is incorporated by
way of a thermo-electric system for the main burner. Flame Failure Protection will shut off the gas supply
to the burner in the event that the pilot burner goes out, so that un-burnt gas is not expelled.
This is an
important safety feature which is slowly becoming law throughout the world
.
1.
Open the oven door. Depress the oven temperature
control knob and rotate anti-clockwise to the ‘PILOT’
position.
2. While holding the oven temperature control knob
depressed, press the piezo ignition button to ignite the
pilot burner. Repeat Items 1 and 2 until the oven pilot is
lit.
3.
View the oven pilot burner is alight by checking through
the pilot viewing holes checking through the hole in the
front of the sole plate with the oven door open.
4.
Release the gas control knob approximately 10-20 seconds
after lighting the pilot.
5.
The pilot should now remain alight - if not, repeat Steps 2 to 3 above.
Oven - Main Burner / Thermostat
1.
With the pilot burner alight, rotate the thermostat control knob on the front control panel to the
desired oven temperature setting required, this will regulate the gas supply to the oven main burner.
2.
To turn the oven main burner “OFF”, simply turn the thermostat control knob to the “OFF” position.
Turning the Oven to ‘Stand-By’ (Pilot ‘ON’ Only)
1.
To turn off the oven burner / heating, set the oven thermostat to the ‘PILOT’ position, this will turn
the oven ‘OFF’, but will leave the oven pilot burner ‘ON’. In this position the pilot burner will remain
alight, but the oven main burner will not operate until the thermostat control knob is set to a
temperature.
2.
If preheating the oven is required, set the thermostat control knob to temperature 190°C and allow
20 minutes before cooking in the oven to allow the oven to warm up.
Oven ‘Shut-Down’
1.
To ‘Shut Down’ the oven, turn the thermostat control knob to the ‘OFF’ position. This will turn ‘OFF’
the oven and extinguish the oven pilot burner. To relight the oven pilot burner, refer to “Lighting
the Pilot Burner (Oven)” above.
Operation
Pilot Burner
viewing holes
Fig 6
! IMPORTANT
DO NOT USE aluminium foil or trays directly on the cast iron sole plate(s).
NEVER block or cover the openings on each side of the sole plate(s).