Waldorf RN8110G Installation And Operation Manual - page 9
7
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Assembly
NOTE:
• All Models are delivered completely assembled. No further assembly is required. Refer to
the information below for assembly instructions.
• This appliance is fitted with adjustable feet to enable the appliance to be positioned
securely and level. This should be carried out on completion of the gas connection. Refer
to the “Gas Connection” section.
Optional Accessories (Refer to Replacement Parts List)
• Rear Roller Kit. For installation details, refer to the instructions supplied with each kit.
• Plinth Kit. For installation details, refer to the instructions supplied with each kit.
1.
Check that all the feet are securely fitted.
2.
Adjust the four feet to make the Range steady and level.
Gas Connection
NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.
1.
Waldorf Target Top Oven Ranges do not require an electrical connection, as they function totally on
the gas supply only.
2.
It is essential that the gas supply is correct for the appliance to be installed and that adequate
supply pressure and volume are available. The following checks should therefore be made before
installation:-
a. Gas Type the appliance has been supplied for is shown on the
coloured stickers located above the gas connection and next to the
rating plate. Check that this is correct for the gas supply the
appliance is being installed for. The gas conversion procedure is
detailed in this manual.
b. Supply Pressure required for this appliance is shown in the
“Specifications” section of this manual. Check the gas supply to
ensure that adequate supply pressure exists.
c. Input Rate of this appliance is stated on the Rating Plate and in
the “Specifications” section of this manual. The input rate should
be checked against the available gas supply line capacity.
Particular note should be taken if the appliance is being
added to an existing installation.
NOTE: It is important that adequately sized piping runs directly to the connection joint on the
appliance with as few tees and elbows as possible to give maximum supply volume.
3.
Fit the gas regulator supplied, into the gas supply line as close to the appliance as possible.
NOTE: The gas pressure regulator provided with this appliance is convertible between Natural Gas
and LPG as per the ‘Gas Conversion Section’ in this manual.
Ensure the regulator is converted to the correct gas type that the appliance will operate on.
The regulator outlet pressure is fixed ex-factory for the gas type that the
regulator is converted to and it is NOT to be adjusted.
The regulator connections are
3
/
4
" BSP female.
The connection to the appliance is
3
/
4
" BSP male.
(Refer to the “Specifications” section for the gas supply location dimensions).
Installation
Combustible Surface
Non Combustible Surface
Left/Right Hand Side
50 mm
0 mm
Rear
50 mm
0 mm
Fig 1
Rating Plate