Waldorf RN8510GE Installation and operation manual - page 29

27 

Gas Conversion and Specifications

Conversion Procedure 

NOTE: 

These conversions should only be carried out by qualified persons.  All connections must be 

checked for leaks before re-commissioning the appliance. 

Adjustment of components that have adjustments / settings sealed (e.g. paint sealed) can only be 

adjusted in accordance with the following instructions and shall be re-sealed before 

re-commissioning this appliance. 

For relevant gas specifications refer to 

‘Gas Specifications Tables’ 

at end of this section. 

Open Burners. 

1. 

Remove the pot stands, burner caps and burner bodies and the pot stand supports. 

2. 

Remove injectors and replace with correct size injectors as shown in ‘Gas Specifications Tables’ at 

end of this section. 

3. 

Refit the pot stand supports, pot stands, burner caps and burner bodies. 

4. 

Re-light main burners and check flame size on simmer (LOW) position. 

Adjust low fire adjustment screw on open burner gas control valves to 

obtain desired flame size. 

NOTE: The 'Low Fire Screw' should be sealed with coloured paint on completion of low fire 

adjustment. 

Ensure that the Appliance is isolated from the gas supply before commencing  

servicing. 

Caution 

Low Fire Screw 

For F Options Only, 

Unscrew and remove Main Injectors. 

For PF Options Only, 

Unscrew and remove Main and 

Pilot Injectors.