Walimex PBS-400 Instruction Manual - page 12
12
3. Let the device cool down.
CAUTION! Danger of burning on the lamp. Let the device cool down
for approx. 30 minutes.
4. Screw in lamp:
Screw in lamp carefully.
WARNING! Danger of electric shock. Always screw in the lamp as to
avoid touching in the socket, when the device is switched on.
5. Screw out lamp:
Screw out lamp carefully and store it securely.
6.4 Connect to power supply
1. Switch off device.
See Switch device on and off.
2. Compare the local power supply with the connected load of the device.
See Technical specifications.
If the values differ, please contact info@foto-walser.de or tel. +49 84 32
/ 9489-0.
3. Connect the power cord with the socket on the device and with the
power socket.
6.5 Charge accumulator of powerpack
1. Connect the powerpack with the local power supply
or
2. Slide on the accu compartment and remove the accumulator by pulling
the strap.
3. Put the accumulator on the charger.
4. Connect the charger with the local power supply.
5. After charging the accu (approx. 3 hours), take out the accumulator
from the charger and insert into the powerpack. Close the accu
compartment.