Walker Bay 275H Assembly Instructions Manual - page 2
!
$
&
!
%
&
"
Bow Section
Aft Section
Fasten nut tightly
4%-0,!4%
4%-0,!4%
Tools you will need:
Remove paper template.
Drill with bit #11
Screwdriver
RETROFIT RID TRACK ASSEMBLY INSTRUCTIONS FOR NON RID READY BOATS
Cut out template on corner of page.
Align port (left) template with outside of
port gunwale lip and first rib on aft edge.
Using a drill gun & bit #11, drill first
hole. Be careful to drill hole perpen-
dicular to hull.
Insert bolt and washer from inside
boat. From outside, attach nut
loosely, do not tighten yet.
Align track with gunwale lip and drill
remaining holes to match pre-drilled
holes in track.
Insert bolts & washers for each hole,
attaching nut loosely.
With both tracks in place, drill holes for bow track as in step 6.
Once all nuts & bolts are in place on forward track, tighten all nuts
working from bow to center, then aft to centre.
Repeat steps 1 through 10 on starboard (right) side of boat.
At 4th hole (track end), fit rectangular
washer onto track.
Use bolt identified as CONNECTION
HARDWARE.
Slide bow and aft track section with
washer in place until they touch
connecting bolt.
Align last hole in track
with hole drilled on boat.
#