Walkera WK-0405 Manual - page 7

6

Receiver Identification

Receiver Identification (Fig. 3):

Fig. 3

Fig. 4

1. Aileron servo. Connect to the aileron servo.

2. Elevator servo. Connect to the elevator servo.

3. Right motor. Connect to the right motor of

    helicopter.

4. Left motor. Connect to the left motor of

    helicopter.

5. Power cable. Connect to the battery.

Aileron servo

Elevator servo

Right motor

Left motor

Power cable

Switch Between Left-Hand and Right-Hand Throttles

Plastic flakes

Throttle arresting spring

Fixing screws

of Plastic flakes

Fixing

screw of

linkage

Throttle DIP Switch (switching

to left end fits right-hand throttle

control; switching to right end fits

left-hand throttle control).

Remove the battery pack, RF module and the 4 fixing screws in the back cover of

your WK-0405, and take off the back cover (Note: don't break cables inside). Unscrew

the fixing screw of linkage using cross screwdriver and fix the linkage of another side

using the screw. And then remove the throttle arresting spring to fix in your expecting

side. Unscrew the fixing screws of plastic flakes to remove the plastic flakes, and then

fix them in your expecting side using the screws. In this way physical refit has been

finished (Fig. 4).