Wallenstein PTO62 Installation Instructions Manual - Mount The Pump
Page 7 of 12
Pump Installed
Positioned
The Backhoe & tractor should always be located on a level, dry area that is free of debris and other
foreign objects. When attaching the hydraulic pump to the tractor, follow this procedure:
Mount the Pump
1. Make sure that all bystanders, especially
small children are clear of the work area.
2. Make sure there is enough room and
clearance to safely back up to the Back-
hoe.
3. Stop close enough so the length of the
hydraulic lines allow the pump to be
mounted to the tractor. Set the park
brake and remove the ignition key.
4. Retract the lock collar and slide the pump over the PTO shaft. Be sure the collar seats in the
groove and locks. Tug on the pump to ensure the collar has locked..
5. Attach the anchor chain to a part of the frame to prevent the pump from turning.
6. Test the installation: start the tractor, set park brake and engage the PTO. Set the throttle at
mid-range.
7. This will power up the hydraulic system on the backhoe, Carefully move a control to ensure
the system is functioning.
Note: any extra length hy-
draulic line: form lines into
loops and secure with tape,
clips or plastic ties.
WARNING
Collision Hazard
During setup, when operating
tractor, boom or stabilizers, ensure the
area is clear of bystanders and operator
is safely positioned. Run the engine at
low RPM and proceed cautiously.
WARNING
High Pressure Fluid Hazard
To prevent serious injury or death from high
pressure fluid:
• Ensure connections are secure.
•
Tighten to torque specification chart.
• Shut off the engine, wear proper hand and
eye protection when searching for leaks
Notice:
Operation Hazard:
Pump is rated to run at 540
RPM only
Z94246
540 RPM