Wallenstein PTO62 Installation Instructions Manual - Backhoe Mounting
Page 8 of 12
Backhoe Mounting
The Backhoe should always be located on a level, dry area that is free of debris and
other foreign objects. When attaching the Backhoe to the machine, follow this procedure:
1. Make sure that all bystanders, especially
small children are clear of the work area.
2. Make sure there is enough room and clear-
ance to safely back up to the Backhoe.
3. Carefully use the dipper arm/stabilizer
legs to tilt the bracket / backhoe on an
angle, so that the bottom attach points
line up with the attach points on the trac-
tor / skidsteer.
4.
Follow the model specific instructions
that came with the backhoe mounting kit
to complete the hookup.
WARNING
Collision Hazard
During setup, when operating
the boom and stabilizers, ensure the
area is clear of bystanders and operator
is safely positioned. Run the engine at
low RPM and proceed cautiously.
WARNING
High Pressure Fluid Hazard
To prevent serious injury or death from high pres-
sure fluid:
• releive pressure on the system before repairing
or adjusting.
• wear proper hand and eye protection when
searching for leaks
• keep all components in good repair
Z94263