Walther 979429.02 Operating Manual - page 10
Rev. 1.2
Operating Manual 979429.02
Page 10 of 13
Walther Systemtechnik GmbH
– D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de
– info@walther-2000.de
5.1 Operating the Menu
Process
Result
1.
For pre-selection of functional parameters, press
the "SET" button
Display PV shows
2.
Enter the codes 0089, 0001 or 0036 by using the
"arrow buttons", then push "SET".
The display switches into the setting mode for a
functional entry (in this case to select the sensor)
and shows the menu entry
3.
Select the menus as listed below by pressing the
"arrow buttons".
All menus will be shown in the display in
accordance with the figure to the left by pushing
the arrow buttons. You will be able to view all
available menus in this group.
4.
After selecting the menu
– in our example
(the active display flashes), confirm with "SET".
The display will now switch into the setting mode of
the selected menu (in this case the setting of the
sensor types to be connected). The upper display
(PV) will show the active menu; the lower display
(SV) will show the symbol for the sensor to be
selected (see table)
.
5.
Select your value by using the "arrow buttons"
and confirm with "SET".
The display will switch back into the menu
selection.
6.
For further settings repeat the steps starting with
number 4
5.2 Changing the Set Temperature
Press / hold the arrow buttons
for changing the set temperature at the control outlet.
The value will be shown in the display.
The display will return to the operating mode after a few seconds.
Depending on the set operating mode (menu “Outy”) follow the setting options according to the
“Parameterization Table Basic Setting and Relay Outputs“ for setting additional outlets.
Gain access to the 3 different setting menus by entering the appropriate code (refer to the
description below).