Walther 979429.02 Operating Manual - page 7
Rev. 1.2
Operating Manual 979429.02
Page 7 of 13
Walther Systemtechnik GmbH
– D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de
– info@walther-2000.de
4 Initial Start-Up
4.1 Mounting and Installation
Perform the installation as described below:
Mount the control unit into a suitable housing.
Connect the temperature sensor.
Connect the consumers / relays to the described clamps.
(see p.9/5.3 )
Connect the control voltage as described (check voltage beforehand)!
(see p.9/5.3 )
Parameterize the control unit according to your requirements.
(see pages 10-14)
4.2 Operating and Display Elements
1. LED "J1-Relais Indicator AL1" (device is heating)
LED "J2-Relais Indicator AL2" (device is heating)
2. Arrow key "UP"
Arrow key "DOWN"
Arrow key "change number and Function
Autotuning"
Set button "select and confirm"
3. LED shows " Load on"
(a signal is sent to the SPS)
Blinking display = "Autotuning on"
4. Display "4-digit display"
1
2
3
4