1. DL manuals
  2. WALTHER PILOT
  3. Paint Sprayer
  4. PILOT WA 800
  5. Operating Instructions Manual

WALTHER PILOT PILOT WA 800 Operating Instructions Manual

Other manuals for PILOT WA 800: Operating Instructions Manual
Manual is about: PILOT WA 800 Series

Summary of PILOT WA 800

  • Page 1

    Walther pilot betriebsanleitung / operating instructions / automatische spritzpistolen / automatic spray guns pilot wa 800 modelle / models das walther pilot- programm • hand-spritzpistolen • automatik-spritzpistolen • niederdruck-spritzpistolen (system hvlp) • zweikomponenten-spritzpistolen • mater...

  • Page 2

    Pilot wa 800 pilot wa 805 mit innensteuerung ohne innensteuerung.

  • Page 3

    Eg-konformitätserklärung wir, der gerätehersteller, erklären in alleiniger verantwortung, dass das produkt in der untenstehenden beschreibung den einschlägigen grundlegenden sicherheits- und gesundheitsanforderungen entspricht. Bei einer nicht mit uns abgestimmten Änderung an dem gerät oder bei eine...

  • Page 4

    Pos. Article-no. Description 14 v 20 815 40 100 piston casing compl. 27 v 66 101 53 015 push-in-fitting 2x 30b-36 parts not applicable 6 v 20 810 12 003 front body 28 v 00 101 01 003 doppelnippel 2x 30a blanking plug not applicable 6 v 20 810 12 003 front bady 14 v 20 815 40 100 piston casing compl....

  • Page 5

    2 optional: air cap for nozzle size v 11 631 12 054* 0,8 - 1,0 mm ø v 11 631 12 204* 1,2 - 1,8 mm ø v 11 631 12 254* 2,0 - 2,5 mm ø 3 v 11 641 40 . . 3* material nozzle (k) 4 v 11 700 09 100 air distribution ring 21 v 20 870 30 . . 3 * material needle 2 optional: air cap for nozzle size v 11 631 12 ...

  • Page 6

    Contents 1 general 1.1 identification of model version 1.2 normal use 1.3 improper use 2 technical description 3 safety warnings 3.1 safety warting symbols 3.2 generally applicable safety precautions 4 assembly / installation 4.1 mounting of spray gun 4.2 connection of input lines 5 operational hand...

  • Page 7

    2 technical description the models of the pilot wa 800-version are automatic air-controlled guns opera- ting in combination with a 3/2-way control valve. Hand, foot or an electrical pulse (sensor etc.) can be used. With internal control: actuation of the 3/2-way control valve directs control air int...

  • Page 8

    4 assembly / installation this spray gun is delivered in completely assembled condition. Before taking the spray gun into operation perform the following preparations: 4.1 mounting of spray gun install the gun in a suitable and stable mounting device as shown in the following example: use the two m ...

  • Page 9

    5.4 spray pattern adjustments the spray pattern of the pilot wa 800 models can be adjusted as follows: adjusting the jet pattern with internal control: an optimum spray pattern can be regulated by using adjust- ment screws b and r . The adjustment screw b regulates the wide/flat jet, the adjustment ...

  • Page 10

    Replacement of material needle 1. Unscrew the draw bar (pos. 24). 2. Unscrew the cap (pos. 23) from piston casing (pos. 14). 3. Pull the material needle (pos. 21) out of the piston casing. Installation of the remaining parts in reverse order. 6 cleaning 6.1 safety warnings • prior to any servicing a...

  • Page 11

    7 repairs / replacements warning prior to any repairs / replacements: make sure that the spray gun is in unpressuri- zed condition, i.E. All air and material inputs must be shut off - if not, imminent risk of injury. Note please use the drawing at the beginning of these operating instructions to per...

  • Page 12

    13 walther pilot repair kits are available for pilot wa 800 models spray guns inclu- ding all wearing parts: article no.: v 16 800 03 . . 3 (standard-versions) article no.: v 16 820 04 . . 3 (low pressure-versions) article no.: v 16 840 04 . . 3 (medium pressure-versions) article no.: v 16 870 02 . ...