WANDERS KANDA User Manual And Installation Manual - Batteries

20

it. If the pilot has gone out you must wait at least 5 

minutes before repeating the above steps. 

8.  Turn the operation switch 

h

UPUIFi

ON

” position.

9.  You can ignite the burner and select the appropriate 

nBNFIFJHIUCZUVSOJOHUIFNPUPSTXJUDI

i

 to the 

left.

10.  To extinguish the fire, you turn motor switch 

i

 all 

the way to the right; the pilot keeps burning.

 5PFYUJOHVJTIUIFQJMPUUVSOi

O I

” switch 

g

UPi

O

”.

12.  Close the gas tap.

Lighting the hearth for the first time

 When you light your gas unit for the first time, the 

hearth must ‘anneal’. The unit has a heat resistant lac-

quer which must still burn in. Though this may give an 

unpleasant smell, it is otherwise harmless. It is advisable 

to turn onto high for about three hours while airing the 

room well.

Some deposit may form on the ceramic glass of the door 

of the hearth. You can easily remove this deposit with a 

damp cloth and if necessary some cleansing agent for 

ceramic rings when the glass has cooled down.

Ensure that the logs are not placed in front of the pilot 

flame. The gas must be able to stream freely to the main 

burner. The main burner is located underneath the log 

set. See page 25 for placing the log set properly.

It is advisable to keep the pilot flame burning in heating 

seasons to prevent condensation and possible calcifica-

tion on the inside of the door.

Batteries

The batteries of the remote control and the receiver have 

a life expectancy of about one year. It is advisable to use 

alkaline batteries.

:PV OFFE UP SFQMBDF UIF CBUUFSJFT XIFO UIF -&% TUBSUT

CVSOJOHMFTTCSJHIUBOEUIFXPSEi

BATT

” appears on the 

display.

3FQMBDFUIFCBUUFSJFTPGUIFSFDFJWFSXIFOEVSJOHJHOJ

-

tion you hear long sound signals (0.8 sec. sound fol-

lowed by 0.2 sec. no sound) (see page 27).

Replacing the batteries in the remote control

Open the lid on the backside. Carefully remove the 

square 9V battery and disconnect it from the contact 

clip. Avoid pulling the cable. Connect the new battery, 

put everything back and close the lid.

Replacing the batteries in the receiver

Carefully pull the whole receiver from the holder behind 

UIFTFSWJDFnBQ TFFQBHF4MJEFUIFMJEPQFOSFNPWF

the batteries from the battery holder, insert 4 new 1.5V 

CBUUFSJFT UZQF-3PS""XIJMFNBLJOHTVSFUIBUUIF

and – signs on the batteries correspond with those in the 

holder. Close the lid and place the receiver back in its 

holder.

Maintenance

Minor maintenance

You can clean your hearth on the outside with a damp 

DMPUI UIBU EPFT OPU HJWF PGG nVGG BOE POMZ XIFO UIF

hearth is cold. If any coffee or other liquid is spilt on 

the ornamental frame while the hearth is burning, then 

put off the stove immediately. Once the hearth is cooled 

off, you can remove any stains with a damp cloth. Any 

deposit behind the door can be removed with a vacuum 

cleaner. Please go to page 25 for instructions on how to 

open the door.

Do not use any aggressive cleansing agents, abrasives or 

stove polish.

Annual maintenance 

Your hearth should be inspected and maintained by a 

qualified installer at least once a year. The following 

parts should be checked: 

t 5IFHBTUJHIUOFTTBOEnVFHBTUJHIUOFTTBOEDPNCVT

-

tion-air supply tightness.

t 1SPQFS PQFSBUJPO PG UIF HBT DPOUSPM CMPDL UIF UIFS

-

mocouple circuit (safety device for unexpected gas 

Discolouration of walls, ceilings and grates

The walls, ceilings and grates may show some discol-

ouration after lighting your hearth. This is caused by 

the dust particles that burn in the convection cover. 

5IJTJTBOBUVSBMQSPDFTTGPSXIJDI8"/%&34DBO

-

not be held responsible. To minimize discolouring 

we refer to the advice given for atmospheric hearths. 

Your installer can give you more information about 

this.

Newly-built house or recently renovated? 

It is advisable to wait six weeks before lighting the 

stove in a newly-built house that has recently been 

completed, or in a space that has recently been reno-

vated drastically. The walls and ceilings still contain 

gases, softeners and moisture from plasterwork or 

paint. The warm air-streams may discolour the dust 

particles in the space which may stick to walls and 

ceilings. Even the moisture in the walls and ceilings 

will become warm and may cause yellow stains.

Avoid finger marks

%POPUUPVDIUIFHMBTTPGUIFTUPWFXJUIZPVSmOHFST

Finger marks will burn into the glass and cannot be 

removed later.