WangYe WY50QT-58 User Manual - page 9
- 12 -
Abrasion mark of the brake
(
Fig
16)
(1) Reference marks
(2) Indicate marks.
If fully brake. Change the brake block when reference marks and indicate marks are
situated in a straight line.
Notice :
Once maintenance for brake system is needed, find the nearest professional
repair department . Make sure the parts for replacement were made by our company.
TYRE
check the tyre pressure regularly and adjust if necessary.
•
Check when the tyre cooled
•
Check if there is any metal trash or gravel in the groove of tyres
•
Check if any metal trash or gravel in the groove of tires.
•
Replace the tyre when it wears out to the abrasion mark.
ADMONITION:
•
If the tyre pressure dose not accord with the standard, it will possibly cause traffic
accidents.
•
It is dangerous to use a worn tire because the friction between tyre and road will be
affected which will possibly bring trouble to driving or even cause an accident.
Fig16
- 13 -
Start engine (
Fig
17)
•
Put the key into the key hole and turn to “ ”.
•
Electric starter: press start button (1) to start engine, don’t keep the start
button presssed more than 5 seconds each time.
NOTICE:
•
Electric starting is based on grasping the brake handle.
•
If electric starting doesn’t work, there must be a break for 30
seconds before you start the engine with it again
•
When start the engine in cold condition, please warm
up engine for 3 minutes before running
•
The engine will be over heated if it works for a long
time at idle speed in an extremely hot day, you need to
power off the engine immediately.
Fig17