WANHAO Duplicator 5S User Manual - page 8
7 . The main cable in the power brick can be
6 . The plug has a sliding collar. When
5 . Next take the power plug out of the wall
slot.The flat side of the power plug
S B
switch and U
has to face towards the top of the Duplicator5 .
step is to make sure the Duplicator5 turned off. This
the Duplicator5 , in the round hole next to the on/off
Now the next step is to give the Duplicator 5 power.
This is done by attaching the external power supply.
Detaching the power supply
1. If the power supply has to be detached, the first
is done by pressing the power switch to 0.
First make sure the power switch is in the OFF
position, this is when the button at the back is
pressed to [0].
2. The corresponding power cable (for your country)
has to be inserted in the power brick of the power
supply.
3. The connector has to be inserted at the back of
4. Now plug the external power supply into the wall
socket.
socket.
removing the plug from the machine, gently
slide the collar outwards which will release
the plug and allow it to come out with ease.
CAUTION
: Please make sure not to pull
the cable. Excessive force may result in
breaking this component.
detached by pulling it out gently.
C1 Install Power Supply
S
S
S
S