Warmington Traditional Fire - Gas 1000 Installation Instructions Manual
23 November 2016
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm………….Copyright ©
1
Traditional brick built open Gas fire & Gas burner
Installation Instructions
Traditional Fire - Gas 1000-1200-1500
Not included:
Bricks and Bricklaying
Hearth and Plinth
Installation
NOTE ON TRAD FIRES
Like the traditional brick built fire
of yesteryear, the Warmington
Traditional fire is built with the
experience and techniques of
the past. These make a grand
statement in the home, however
they can lack in efficiency
.
Note: FLUE SYSTEMS casing...
Flue system may require to be doubled lined to comply.
Refer to relevant standard.
Note: BRICK OUT GUIDE details...
The bricking guide will come with the bricks, once
purchased.
NOTE : Non-combustible
cladding eg:
10mm Promina Board,
10mm Supalux, Latex Plaster.
(not supplied)
The fireplace is constructed and tested to comply with NZS 4558(int):2013 ‘Decorative gas log and other fuel effect appliances’.
Keep these instructions for further reference. Ensure that you have the correct and current installation details for the Warmington fireplace.
Installation
The Warmington unit is to be installed by a certified Warmington installer or an approved NZHHA installation technician.
see www.homeheat.co.nz/members for a certified NZHHA SFAIT Installer in your area.
A licenced certified gas fitter and licenced electrician are required to run power and gas supplies as required to the unit and any commissioning as part of the
installation process.The heater must be installed according to these instructions and in compliance with all relevant building, gas fitting, electrical and other
statutory regulations.
Related documents
Fire and flue system installation, and instructions to comply with NZS 5601.1:2013, 3645.1
(Int):2010, 3645.2(Int):2010, 5266:2014, 2918:2001.