Warmington Traditional Fire - Gas 1000 Installation Instructions Manual - page 16
23 November 2016
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm………….Copyright ©
16
To light:
Open the front cover by pulling in outwards.
Push in the ignition control switch and hold in the ‘PILOT’ position for 5-10 seconds until you
can hear the gas come through the pipe – making sure the ignition switch is pressed in firm-
ly.
To strike the igniter, turn anti clockwise to the * STAR position (
w
ith the ignition switch still
firmly pressed in
)
until you hear the pilot ignite with a ‘click’. Repeat this process 2 or 3 times
if necessary.
Once the pilot flame is lit, hold this position for 3-5 seconds, then gently let the ignition switch
out, and set the flame control to high. It may take a few seconds for the burner to light all the
way across.
Once the flame is established, adjust to the desired setting and close the cover.
To shut down:
Open the cover by pulling it outwards.
Turn the control ignition switch to ‘PILOT’ and the flame bed will extinguish.
Pilot light may be left on and the pilot flame will still burn.
OPERATION OF YOUR WARMINGTON GAS CONVECTION FIRE (MANUAL START ONLY)
Note: Control Valves are factory set but may require adjustment onsite
Turn Appliance off & remove front plastic cover on Igniter. Pull cover to slide off.
Unscrew test nipple on the burner manifold & fit the test gauge securely - see diagram.
To set the High: Light the burner & turn to high - then adjust the high screw to the desired pressure - see specs.
To set the Low: Light the burner & turn to low - then adjust the low screw to the desired pressure - see specs.
Extinguish appliance, remove test equipment and secure test nipple.
Check valve & burner for correct operation & check fire for gas leaks.
Note: When the base screw is removed, gas will leak from the out let, ensure that the pilot
is not adjusted or the screw is removed when the fire is burning.
Adjustment of Pilot - 3 Flame: Unscrew base screw as shown in Diagram 2.
Insert a screwdriver as shown in Diagram 3 and adjust the adjustment screw up inside
the 3 Flame Pilot to adjust the flame height.
The flame must always be passing over the Electrodes &/or File Tube on either side.
Replace the Base screw and check for leaks.
Correct operation of 3 Flame Pilot
3 Flame Pilot in
3
2
Note: to Gasfitters
The 3 flame pilot may need adjust-
ment after a period of running time
on set up as the increase in heat in
the fire will induce a higher draft in
the fire, and may pull in flame away
from the file Tube causing the fire
to shut down.
ADJUSTMENT OF THE PILOT for electronic and manual burners - done by gasfitter only