Watchguard Firebox M200 Hardware Manual - page 7
Hardware Guide
5
Hardware Specifications
Reset Button
Use the Reset button to reboot the Firebox or reset the configuration to factory-default settings.
To reboot the Firebox, press and hold the Reset button for five seconds.
To reset the Firebox configuration to factory-default settings, use the procedure in “Restore
Factory-Default Settings” on page 7.
Interfaces
Firebox M200 and M300 devices have eight network interfaces, two USB interfaces, and one console port.
Serial port
An RJ45 connector for the serial interface is located to the left of the USB interfaces. You can connect
to this serial interface to log in to the Fireware command line interface.
For more information about the Fireware command line interface, see the Fireware Command Line
Interface Reference.
Dual USB interfaces
Connect a USB storage device to use for USB backup and restore, or to store a support snapshot. For
more information about USB functions, see the current Fireware Help.
RJ45 interfaces
Interfaces 0 - 7 are RJ45 Ethernet interfaces that support link speeds of 10, 100, or 1000 Mbps. Each
RJ45 interface has a pair of indicators. The right indicator shows the interface connection status. The
left indicator shows interface activity.
Interfaces 0, 1, and 2 do not support 10/100 half duplex.
Indicator
Indicator color
Interface Status
Connection (right)
Yellow
Link at 1000 Mbps
Green
Link at 100 Mbps
Not lit
Link at 10 Mbps, or no link
Activity (left)
Yellow, blinks
Power on, network activity
Not lit
Power off, no connections