Watchguard VSPV13M User Manual - Factory Default Values
Factory Default Values
IP Address
Port Number
192.168.1.10
88
User Name
Password
admin
admin
* The 3G connection setting is not completed when the
Internet indicator is blinking in the fashion below:
5 seconds on 0.5 second off 0.5 second on 0.5
second off 5 seconds on
Always On
Indicator
Blinking*
Connected
Disconnected*
Internet
Connected
Disconnected
LAN
Status Indicator
Activate Push Video
4
Check Your Connection
When you complete the network setup, check your
connection as instructed below.
Step1: Switch your network mode to 3G mode on
iPhone or iPad.
Step2: Start EagleEyes, and select the connection you
just added to see if you can access VSPV13M
successfully.
If yes, your network setup is successfully.
If no, go to Step3.
When “Push Video” is enabled, you’ll be able to receive event notifications on your iPhone / iPad within 5 seconds.
Before using this function, make sure you’ve inserted a micro SD card to VSPV13M for event recording.
Step1: Open “EagleEyes”, and switch the
Push Video button to “ON”. You’ll
receive the message indicating that
Push Notification (Push Video) is
on.
Step2: Return to the main menu of your
iPhone / iPad. You’ll receive event
notifications when there’s a human
detection event. Select “View” to
immediately play the recorded clip.
Push Video
Push Video
Button
Button
Step3: Switch your network mode to wireless mode on
iPhone or iPad.
Step4: Start EagleEyes, and add a new connection with
the IP address (e.g. 192.168.2.25) and port
number (e.g. 88) you set in Step3 of “3.
Configure with iPhone / iPad”. Then, see if you
can access VSPV13M with this new conection
successfully.
If yes, return to Step7 ~ 8 in “3. Configure with iPhone /
iPad” for port forwarding.
If no, start from Step3 in “3. Configure with iPhone”
again to reconfigure your VSPV13M.
Digital PTZ
Function
White LED
Slow Shutter
Disabled
When Push Video is “On”
fixed to “Auto”
fixed to “Level 2”
ON / OFF selectable
When Push Video is “Off”
Manual / Auto / Timer selectable
Level 0 ~ 5 selectable
“Push Video” is an active notification system, different from traditional FTP, Email and SMS notification methods. It’s more
active and stable, but also easier to be affected by your network bandwidth.
It functions as a key to your surveillance area. When it’s enabled, your surveillance area is considered to be locked on, and
the functions or parameters listed below will be disabled or fixed to ensure “Push Video” gets the optimized event images.