Combination water softener / tannin filter installation / operation manual.
Installation procedure 1. Identify installation location for water softener. Piping should be such that all household water, with the exception of outside hydrants, flows through softener. This system and in- stallation must comply with state and local laws and regulations. 2. Connect water piping. ...
Start-up procedure fill the mineral tank with water: press and hold the extra cycle button for 5 seconds. Dis- play will indicate step 1, which is the backwash cycle (as shown above). Once the display indicates step 1, slowly open bypass valve and let water run to the drain for approximately 5 minut...
Setting current time of day user programming user programming mode steps (refer to chart above for user mode indications) 1. Press the up and down buttons for five seconds while valve is in service. Display will enter programming mode. (note: timer will discard any changes and exit programming mode ...
User programming (cont’d) control programming is now complete. Press the extra cycle button and the control will exit from the programming mode and resume normal operation. 3. Adjust regeneration time: press the extra cycle button to advance to next option. This setting determines the time of day th...
Maintenance / warranty information all brassmaster and brassmaster plus wa- ter softeners feature the assured perfor- mance modular (apm) design. If you expe- rience a failure of any valve component, the brass module can be easily removed and replaced with a factory remanufactured re- placement modu...
Official warranty water control corporation brassmaster plus series water softeners limited warranty water control corporation warrants the control valve to be free of manufacturers defects for a period of 5 (five) years from the date of installation, and the fiberglass reinforced mineral tank, and ...
Watercontrolcorporation 7150143 rd avenw●ramsey,mn55303 phone:1‐866‐405‐1268●fax:763‐427‐5665 www.Watercontrolinc.Com.
