Water HP-Soft-2 Installation Manual - page 7

8.  Connect and route the valve drain hose. 

  Use the provided drain hose to attach to the valve drain fitting. To keep water pressure from blowing the 

hose off, use a hose clamp to secure. 

9.  Locate the other end of the hose at a suitable drain. 

  Tie or wire the hose in place at the drain point. Also provide an air gap of at least 1-1/2" between the end of 

the hose and the drain point. 

Figure 2 

A – Adapter overflow elbow 

B – Overflow hose 

C – Valve drain hose