Water HP-Soft-2 Installation Manual - page 9
shipment and installation. The media inside the resin tank may also have become disturbed during shipping.
The following procedure will help re-position the media, sanitize, flush and condition your water softener:
a) Add 1-1/2 ounces of common household bleach to the water in the cabinet (brine tank).
b) Following the directions in the Control Service Manual, manually advance the softener through each step of
regeneration pausing for 10 minutes in each cycle except the Fill cycle (see step c.).
c) See the enclosed Water Softener Performance Data Sheet for the Fill cycle time associated with your model.
d) Repeat step 19a and 19c after any service has been performed on your water softener.
20. Turn ON the gas or electric supply to the water heater.
21. Remove the brine tank cover and add salt into the tank. Use only nugget, pellet or coarse solar salt with a purity
of 99.5% or higher. DO NOT use rock, block, granulated, and ice cream-making salts, or salt with iron removing
additives. Keep the cabinet cover closed unless servicing or refilling with salt.
22. Connect electrical power by plugging the transformer into a (120 volt) outlet.
Figure 4
23. With the valve
In Service, manually initiate a regeneration as the final installation step. This regeneration will:
a) Fill the brine tank with the appropriate amount of water for the 1st regeneration
b) Complete the final flushing and conditioning of the water softener.
c)
Re-classify the resin bed if the bed was disturbed during shipping.