Water Right ISP1-1044 Installation instructions & owner's manual - page 9
9
LIGHT
/
ALARM OPERATION
:
Light panel operation with audio alarm:
On the right side of the control valve there are 3 lights — green, yellow and red.
1. The green light indicates the unit is in the service position delivering
soft water.
2. The red light indicates the unit is in the regeneration cycle.
3. The yellow light with the red light indicates a failed chlorine
regeneration signal and the unit is still in regeneration.
4. The yellow light with a green light indicates a failed regeneration
and the unit is now in the service position. An audio alarm will
also sound every minute. This will signal a failed chlorine
regeneration.
To stop the alarm simply unplug the unit, wait 5 seconds,
then plug it back in. This will clear the alarm and clear
the yellow light. You will not lose any programmed
information on the Iron Soft Plus timer.
Check salt level in brine tank:
If salt level is low this will trigger the yellow light and alarm. Remember to always keep salt above
water level. If salt level is good, contact dealer or refer to the troubleshooting section in this manual.
Green
Yellow
Red
Green light is on indicating service position and
that the last regeneration was proper.
1. SERVICE POSITION:
Raw water enters control head and flows down
through the Zeolite mineral, removing hardness
and iron (neutralizing acidic water conditions on
ISP-1 models).
2. BACKWASH POSITION:
Raw water enters control head and flows into
lower distributor upward through mineral bed and
out to drain, lifting and cleaning turbid particles
from Zeolite bed.
2
WATER CONDITIONER FLOW DIAGRAMS
:
1