Waterco 20 SC Owner's Manual - page 3
I pg 03
Waterco Hydrochlor®
Ezy Timer
Programme the chlorinator timer to turn on or off at any time that suits your lifestyle.
The Timer controls power to the Chlorinator controller. The timer has a liquid crystal display (LCD)
to indicate the time of day and current operating mode.
5IFSFBSFLFZTXIJDIBSFVTFEGPSTFUUJOHUIF5JNF5JNFSTBOEPQFSBUJOH.PEFT5IFGVODUJPOPG
these keys is described below:
HOME
Display current Time of Day or to exit Timers setting.
TIMER
Toggle between
START
and
FINISH
of
Timer 1
and
Timer 2
for summer and then
for winter. Set times can be altered while displayed.
Timer 1 START
Timer 1
FINISH
Timer 2 START
Timer 2
FINISH
Timer 1 START (winter mode)
Timer 1 FINISH (winter mode)
Timer 2 START (winter mode)
Timer 2 FINISH (winter mode)
RESET
Reset time to 0:00 and timers to the default programming.
HOUR
Enable changing the hours for the current time of the day or
Timer Settings
.
Subsequent presses will change the hours immediately.
MIN
When first pressed this key will enable changing the minutes for the current time of
the day or
Timer Settings
. Subsequent presses will change the minutes immediately.
WINTER
By selecting WINTER, hours of operation will be reduced to save energy during the winter
months. Deselecting WINTER will instantly return to increased hours of operation for the
non-winter months (AUTO operation).
SUPER CL
Superchlorination – If the SUPER CL key is pressed once the
Hydrochlor®
will be
set to produce chlorine at maximum level for 24 hours non stop overriding previous
programming and the letter SC will be displayed on the LCD screen. Pressing the
SUPER CL key again when the SC is displayed on the LCD screen will disable the
super chlorination and revert to the original programming.
MODE
Sequences through the modes below:
OFF
All timers off
ON
Timer switch is on all the time
AUTO
Timer are operational according to setting.
Note: MODE does not override SUPER CL.
CHLORINE
PRODUCTION
Set chlorine production level.
CONTROL
CHLORINATOR
Overrides the timer setting, stops chlorine production
OVERRIDE SWITCH
and disables pump protection for pool maintenance
Electrolytic Salt Cell
The
Hydrochlor®’
s salt cell consists of a series of titanium electrodes with opposite charges.
Hydrochlor®’
s clear salt cell housing allows visual inspection of the salt cell plates and enables
monitoring of chlorine production.
The cell housing is constructed using clear U.V. stabilized acrylic. Both anode and cathode of the
self-clean chlorinator are made from uniquely coated titanium plates for extra durability.
Self-Cleaning
Hydrochlor®
Self Clean Salt Cell has the added ability to reverse the polarity of the voltage to
clean calcium build up off its electrodes.
The
Hydrochlor®’
s electrodes, the anode and cathode and hold an electrical potential difference
between them for a designated period of time. This difference is reversed after that period of time
has expired and then the anode becomes the cathode and the cathode becomes the anode.
The reversing of polarity or electrical potential difference will then start to remove any calcium
build-up, which may have been deposited onto the cathode.
This continuous reversing of polarity will keep the cell clean from calcium deposits during its
operation, providing the chemical balance and flow of the pool water thru the cell is maintained
within normal parameters.
It is recommended that you obtain regular water chemistry tests from your local pool professional
to ensure your water balance is within range.
Battery Backup
The Hydrochlor® comes with a Lithium battery incorporated to save your settings in the event of a
power failure. The battery is rated to last 5 years.