Watersnake GPSmart Owner's Manual - page 14
Watersnake
14
RECALLING A STORED ANCHOR SITE
From any mode, while holding down the “A” button, press
and release the appropriate directional button. The “A”
button can then be released and your boat will navigate in
a straight line directly to that location and anchor at the
selected, previously recorded site.
The motor will “beep a tune”
(multiple consecutive beeps) to indicate
that the anchor site has been successfully
retrieved.
The motor will emit two “growls” and exit if
the memory location is empty or the boat
is not within 1 mile of a memorized location.
RECALLING LAST ANCHOR SITE
From any mode, press and hold the “A” button for 5 seconds.
The “A” button can then be released and your boat will
navigate directly to the last anchor location used.
The motor will “beep a tune”
(multiple consecutive beeps) to indicate
that the anchor site has been successfully
retrieved.
The motor will emit two “growls” and exit if
there is no active last memory location or
the boat is not within 1 mile of the previous
location.
When recalling a stored anchor site if you hold the buttons for more
than 5 seconds you will over-write that existing memory location
with the boat’s present location, erasing it.
The system will calculate a beeline to the selected anchor site.
Make sure there are no obstructions between you and the anchor
site prior to recalling a location.