Watersnake GPSmart Owner's Manual - page 9
www.watersnake.com.au
9
ELECTRICAL INSTALLATION
The Watersnake GPSmart motor requires 24 Volts DC to Operate. Typically,
(2) 12V deep-cycle marine batteries are used.
BASIC INSTALLATION
Your Watersnake GPSmart system is provided with a factory installed 6’ power
cord with 5/16”ring terminals for connection to breaker/battery terminals
or power lugs. Please note that it is mandatory to install a fuse or breaker
protection for the system circuit. This protection should be rated for 50A, 24V.
If you boat is already wired with a 24 volt power system with appropriate circuit
protection, simply connect the white wire to the positive lug and the black wire
to the negative lug. Should you boat use a trolling motor plug or not have a
24 volt trolling motor circuit, please refer to additional instructions below or
contact an approved system installer.
PLUG INSTALLATION
If your boat is already wired with a 24 volt trolling motor battery system it may
be necessary to install a plug on the end of the main power conductor in order
to work with your boat.
There are many different plugs on the market, but generally it is possible to
obtain the appropriate plug from your local boating supply store. Please make
sure that the plug you install is rated for 50A, 24V. Should you have difficulty
locating the appropriate plug,please contact your nearest Watersnake dealer ,
and we will do our best to assist you.
Batteries produce and contain harmful materials that may result in personal
injury and/or property damage if improperly used. Refer to your battery
manufacturer’s guidelines for charging, discharging, storage and care instructions.
Be sure all switches/circuit breakers are in the OFF position and fuses are
removed when making battery connections. Failure to do so may result in
personal injury and/or property damage.
DO NOT connect the trolling motor batteries to any other device, including the
main outboard engine.
Verify that all conductors and connectors are rated for at least 50 Amperes
and 24VDC. All circuits MUST be protected using a 50A fuse or circuit breaker
in series with the positive lead. Failure to do so may result in personal injury and/or
property damage.
The following process is of moderate difficulty. Should you not feel comfortable
performing the steps listed below, we recommend that you contact an
authorized installer to complete this process for you.
GPS
MART