WATT AGE odyssey ep arf Assembly Instructions Manual - page 5
5
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
Here's a List of What We Used to Finish Our Odyssey EP ARF:
QTY. 1 759134
Hitec Electron 6 Micro Receiver
Hitec Dual Conversion FM RX Crystal
QTY. 3 444035
Cirrus CS-6.2 Micro Servos
QTY. 1 128482
Wattage IC-5A Micro ESC
QTY. 1 128514
Wattage 7 Cell 300Mah 2/3AAA NiMH Flight Battery
QTY. 1 130108
Wattage PF-12 AC/DC Park Flyer Charger
QTY. 1 869020
Dubro Double-Sided Tape
IMPORTANT
The Cirrus servos and Wattage ESC use a universal connector that is compatible with all name-brand radio control
systems. The part number listed for the Hitec Electron 6 micro receiver is compatible with Hitec & Futaba radio control systems only.
This receiver is also available for JR and Airtronics radio control systems.
When you purchase the Hitec Electron 6 micro receiver, you must also purchase a Hitec brand crystal compatible with the receiver.
The crystal must also be on the same frequency as your transmitter. Note that the Hitec Electron 6 micro receiver uses a dual
conversion FM Hitec crystal.
OUR RECOMMENDATIONS, CONTINUED....
❑
Kwik Bond 5 Minute Epoxy # 887560
❑
Kwik Bond Thick C/A # 887510
❑
# 0 & # 1 Phillips Head Screwdrivers
❑
Magnum Z-Bend Pliers # 237473
❑
Wire Cutters
❑
Needle Nose Pliers
❑
Adjustable Wrench
❑
Excel Modeling Knife # 692801
❑
Scissors
❑
Electric or Hand Drill
❑
Assorted Drill Bits
❑
Ruler
❑
Pencil
❑
220 Grit Sandpaper w/Sanding Block
❑
Masking Tape
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks # 864204
❑
NHP Epoxy Mixing Cups # 864205
SECTION 2: TOOLS AND SUPPLIES REQUIRED
The tools and supplies listed below will be necessary to finish the assembly of your Odyssey EP ARF. We suggest having
these items on hand before beginning assembly.
The preinstalled power system features a BEC style plug on the motor. The recommended Wattage IC-5A speed control and 7 cell
300Mah 2/3AAA NiMH flight battery also feature BEC style plugs. If the ESC and/or flight battery you choose to use do not feature
BEC style plugs, you will need to either solder a compatible plug onto the motor or solder BEC style plugs onto your ESC and
flight battery. If this is the case, you will also need a soldering iron, solder and heat-shrink tubing in addition to the items above.
Optional Items Include:
Cirrus MRX-4 Super-Micro Receiver
Wattage 8 Cell 300Mah 2/3AAA NiMH Flight Battery