WATT AGE odyssey ep arf Assembly Instructions Manual - page 9
9
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
Mix a generous amount of 5 minute epoxy and carefully apply a thin layer to the root ribs on both wing panels.
WARNING
For maximum wing strength, make sure to cover the entire surface of both root ribs.
❑
Fit the wing panels back together and realign them. Remove any excess epoxy that squeezes out of the joint
using a paper towel and rubbing alcohol, and hold the wing panels together firmly until the epoxy sets up - about 10
minutes.
❑
After the epoxy fully cures (about 1 hour), double-check that there are no gaps in the center section joint. If there are,
mix up some more 5 minute epoxy and fill the gaps. After the epoxy completely cures, carefully remove the masking tape
from the wing.
Step 2: Mounting the Horizontal Stabilizer
❑
Line up the predrilled holes in the stabilizer with the
predrilled holes in the bottom of the fuselage and secure
the stabilizer into place, using the two M3 x 12 wood screws
provided.
☞
Be careful not to overtighten the screws or you might crush
the stabilizer. The screws should be tightened snugly.
IMPORTANT
When mounting the stabilizer, make sure that
the preinstalled doubler is toward the bottom of the fuselage,
as shown.
❑
Apply a strip of masking tape to the top and bottom edges
of the root rib on each wing panel.
☞
The masking tape will prevent excess epoxy from getting
onto the wing panels when you join them. This will make
cleaning up any excess epoxy a lot easier.
Step 3: Installing the Main Gear Wire
❑
Install the main gear wire by simply sliding the wire
completely up into the slot in the bottom of the fuselage,
as shown.
IMPORTANT
It is not necessary to glue the main gear wire
into place. It is a friction fit. You could glue it into place if you
want, but if it's damaged during a hard landing it is much easier
to repair or replace it if it's not glued in.