Watts Premier Filter Pure UF3 Installation, Operation And Maintenance Manual - Adapt-A-Valve Installation
7
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Open cold water sink faucet to relieve pressure.
Step 11
Step 12
Choosing the configuration that fits your plumbing, attach the adapt-a-valve as illustrated in
the four photos above.
Adapt-a-Valve Installation
Do not use Teflon tape with the Adapt-a-Valve.
WARNING:
Caution: Water supply line to the system must be from the cold water supply line only.
Hot water will severely damage your system.
3/8” Configuration
(With Brass Fittings)
* Insert White Washer
1/2” Configuration
(Without Brass
Fittings)
*
White
Washer
Hot
Supply
Cold
Supply
Hot
Supply
Cold
Supply
Verify contents prior to installation:
( 1 ) - Plastic Adapt-a-Valve with black collet
( 1 ) - Brass Adapter no washer
( 1 ) - Brass Adapter with black washer
( 1 ) - White rubber washer
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve.
Don’t forget to install the white compression washer with the 3/8” configuration.
Brass adapter (A) does not need to be tightened with a wrench, only finger tight.
Black
Collet
A
TIPS:
A
White
Washer
Green Tube Connection - Feed Water
Step 13
Locate the 1/4” Green tube in the Filter-Pure Box.
The tube has
one straight end and one bent end.
Attach the bent, open end
of the green tube into the left side of the system by pushing it
into the quick connect fitting (behind Red Sediment filter head).
Insert the straight, open end of the green 1/4” tube into the
open 1/4” quick connect fitting on the plastic water feed valve
making sure the tube is pushed in all the way to the tube stop.
Green Tube
Adapt-a-Valve