Watts Premier Filter Pure UF3 Installation, Operation And Maintenance Manual - Mounting System Under Sink
8
Mounting System Under Sink
Locate an area best fitted for mounting the system. Allow
approximately 2” (5cm) clearance between the bottom of the
filter housing and the floor of the sink cabinet.
Using the mounting holes on the bracket, mark the location for the mounting screws on
the cabinet wall under the sink.
Screw the (2) self tapping screws into the wall at the marked location.
Hang the module on the screws using the mounting holes in the bracket.
Step 14
Step 15
Step 16
Start up Instructions
Congratulations!
You have completed the installation of your new Water Filtration System.
Please Follow the Startup Instructions.
ON
Turn on water supply at angle stop and open the Adapt-a-Valve. Turn
faucet handle to the open position to start the flow of water through
the unit. Run 3 gallons of water through the unit in order to flush out
the normal black carbon fines (it will “sputter” until the air is purged
out) from the unit. Initially, the water may appear cloudy which is due
to tiny air bubbles and it will clear up shortly. Close the faucet when
finished.
(Check frequently over the next 24 hours to ensure no leaks are present)
Step 1
Step 2
Check for leaks. If you have any leaks, shut off the water supply to your system, tighten
any fittings / housings and restart unit.