Watts Premier WP-2 BVC Installation, Operation And Maintenance Manual - Watts
6
Remove faucet base & spout from their respective plastic
bags. Feed the faucet tubing through the round rubber gasket
which you will find in the faucets parts bag. Peel the white
backing from the upper side of the gasket and press firmly
on to the base of the faucet. From above the sink, feed the
faucet tubing & toggle bolt down through the .5” mounting
hole in the sink.
Peel the white backing from the bottom side of the rubber
gasket, align the faucet base so that the handle is on the
right side and press the faucet base down firmly over the
mounting hole. Turn the handle down (towards you) to the
“ON” position to reveal the tightening screw (located where
the spout will be inserted). Using a Phillips head screwdriver,
turn the screw clockwise until the toggle bolt secures the
faucet base snug onto the sink top, do not over torque toggle
bolt (5lb.in. max)
Once the faucet base is securely fastened to the sink top,
insert the faucet spout into the faucet base until it is fully
seated. Turn the handle up (away from you) to the “OFF”
position.
Connect the 3/8” blue tube from faucet to the 1/4” blue
tube from the system using the 3/8” x 1/4” union provided.
Remove the faucet battery from the plastic bag. Locate the faucet battery compartment drawer on the base of the faucet. Use
a small screwdriver to pry on the notch at the compartment drawer face and slide the drawer out. Insert the battery into the
battery compartment drawer.
NOTE: The + side of the battery faces up. The compartment drawer will not slide in if the battery is installed upside
down.
Once the battery is in place, slide the battery compartment drawer back into the base until it is flush.
When the battery is first installed, both the red and green lights will flash to indicate that both lights are functional. Thereafter, it will
flash green only when the faucet handle is turned to the “ON” position. When your system is ready to be serviced (approximately
six months) you will see the light flash red when the handle is turned to the “ON” position.
NOTE: If your water usage is high the red light may activate sooner than six months indicating the need for filter
replacement.
This faucet provides an electronic monitor that will tell you when it is time to replace the filters in your water treatment
device. The light indicator will be green for the life of the filter, turning red once the life of the filter has been reached.
This can occur after six months of use, or sooner for heavy water usage. The battery life is expected to last one
year, however, under heavy use the battery may need to be replaced sooner. For replacement, look for battery
number CR2354 (Watts p/n:116082) which should be available at your local battery store or contact Watts Premier
at 800-752-5582. You may also order online at www.premierH2o.com.
WATTS
Premier Monitored & Non-Monitored
(Top Mount) Faucet Installation
Step 6
Step 7
Step 8
Step 9
Step 10
Faucet Battery Installation
Minimum
Maximum
Mounting Hole Size
.5”
1.25”
Torque on Toggle Bolt 5lb.in. (max)
Line from Faucet
Line from Unit