Wattstopper CI-355 Installation Instructions Manual - Mounting The Sensor
MOUNTING THE SENSOR
Using a 4-Inch Square Junction
Box with Double-Gang Mudring
1. Pull the high voltage wires into
the J-Box through the conduit
knockout.
2. Connect the high voltage wires to
the appropriate terminals on the
sensor.
3. Align the sensor in the J-Box
so that the mudring mounting
screw tabs on the box match the
mudring mounting holes on the
sensor’s rear housing.
4. Use two machine screws
(included with the sensor) to
attach the sensor to the mounting tabs on the J-Box.
5. Snap the front cover onto the sensor.
Using an Octagonal Junction Box
1. Pull the high voltage wires into
the J-Box through the conduit
knockout.
2. Connect the high voltage wires to
the appropriate terminals on the
sensor.
3. Align the sensor in the J-Box so
that the mounting screw tabs on
the box match the key holes on the
sensor’s rear housing.
4. Use two machine screws (included
with the J-Box) to attach the
sensor to the mounting tabs on the
J-Box.
5. Snap the front cover onto the sensor.
4" Octagonal, 2.25" Deep
*
Junction Box
Ceiling
Sensor
Screws
Front
Cover
4" Square, 2.25" Deep
*
Junction Box with
Double Gang
Mudring attached
Drop Ceiling
Front
Cover
CA-1 Adapter
Rear Housing
Screws
Sensor Flange
*
The Junction Box must be at
least 2.25” deep. If it is not, an
extension ring is required.
Visit our website for FAQs: www.wattstopper.com
Mounting to a 4” Square Junction Box with
Mudring
Mounting to an Octagonal Junction Box