Wattstopper DW 100 Installation Instructions Manual - page 4
4
DIP SWITCH SETTINGS
9
=ON =OFF
1 2 3 4 5
6 7 8
Time
Delay
Walk-Through
ON
Relay 1
Relay 2
Audible Alerts
PIR Sensitivity
8
Auto On
Manual On
Relay 1 On Mode
9
Auto On
Manual On
Relay 2 On Mode
4
High
Low, 50%
PIR Sensitivity
7
Disabled
Enabled
Audible Alert
1 2
5 minutes
Test/20 min
15 minutes
30 minutes
Time Delay
5 6
Trigger
Mode
Initial
Occupanc
y
Maintain Occupanc
y
Re-trigger
Option C
Both Both
Both
Standard
Both
Either
Either
Option A
Either
Either
PIR
Option B
PIR
PIR
PIR
3
Disabled
Enabled
Walk-Through
Trigger
Mode
DW-200 only:
On Mode
1
2
Factory Settings:
All models
DW-100 series
DW-200 series
1
2
'(/$
<
3,5
:
$/.
75,**(5
$/(5
76
5/
<0$1
5/
<0$1
ON/OFF Buttons
Relay 1
Relay 2
DIP Switches
PIR Lens
Detection LEDs
Red = PIR
Green = Ultrasonic
Ultrasonic Cones
Ultrasonic Sensitivity
Adjustment Trimpot
DW-200 shown.
DW-100 has a single
button and the
Ultrasonic sensitivity
adjustment trimpot is
in a slightly different
position.
Button
Hinges
Tabs
ADJUSTMENTS
Sensor Adjustment
Remove the wall plate. Remove the button cap by firmly squeezing together the top sides of the button assembly. Gently pull it away
from the unit.
When the adjustments are completed, replace the button cap by inserting its hinges into the tabs on the main unit and then squeeze the
top of the button while pressing it into the unit. Reinstall the cover plate.
Light Level Adjustment
The light level can be set with loads
ON or OFF. To enable light level control and set the threshold:
1. Make sure the room is lit appropriately.
2. Put the sensor into TEST mode. You have 5 minutes to complete the procedure.
3. Press and hold the
ON/OFF button (Relay 1 button on the DW-200) for 3 seconds, until you hear a beep.
4. Step away from the sensor. After 25 seconds a beep sounds, indicating that the threshold level is set. This threshold is retained,
even if power is lost, until it is re-set or disabled. In the DW-200, light level control only affects Relay 2.
To disable light level control, press and hold the
ON/OFF (Relay 1) button for 7 seconds, until a double beep tone sounds.
Reset to Default
Use the DIP Switch Settings tables on the previous page to return features to factory settings. To reset the DW press and hold the
ON/OFF (Relay 1) button for 10 seconds, until a triple beep sounds. This resets the sensor and disables light level control (the brightest
ambient light will not hold the light
OFF).
Service Mode
To enter service mode set the ultrasonic trimpot to MIN (Fully counter-clockwise).