Wave Broadband Home Network Gateway User Manual - Reset Button

64

Reset Button

There are two modes to the reset button located on the back of your Wave Home Network 

Gateway Server:

1. To reset all Home Network Gateway functionality, excluding Wi-Fi, press and release the reset 

button. 

2. To reset the router and Wi-Fi to the factory defaults, press and hold the reset button for ten 

seconds or more. You will know that you’ve held the button long enough when the Record 

light flashes. 

LED Display

The following LED displays are visible on the Wave Home Network Gateway Server:

Power LED - Appears when the Home Network Gateway Server is currently powered on.

Link LED - Appears when a computer is connected directly via Ethernet to the Home Network 

Gateway Server.

Tel1 LED - Appears when the first telephone line is provisioned and functioning.

Tel2 LED - Appears when the second telephone line is provisioned and functioning.

Battery LED - Appears when the battery is present and charged.

MOCA LED - Appears when the Home Network Gateway Server is currently connected to a 

Gateway Client.

Wi-Fi LED - Appears when the Wi-Fi is on and connected.

Recording - Glows red when the Gateway Server is currently recording.

*You will not be able to disconnect the eSATA drive and connect it to different Gateway Server 

without reformatting and losing all content that was recorded on the drive. You will also not 

be able to connect the eSATA drive to your computer to retrieve recorded content.

3.  Select disconnect, and then press OK.  

4.  You may be presented with a message that the drive is still busy. If this happens, please 

repeat the disconnect process at a later time.