Wave Broadband Home Network Gateway User Manual - page 66
66
Configuring Your Ethernet Connection
If your computer is equipped with a LAN card providing an Ethernet connection, you may
have to configure your computer’s TCP/IP settings. The steps that follow will guide you
through setting your computer’s TCP/IP settings to work with the Telephony Gateway.
Requirements
Make sure you have the following before attempting to configure your Ethernet connection:
• Computer with:
— One of: Windows 2000, Windows XP, Windows Vista, Windows 7, Windows 8, MacOS X
— Ethernet interface
• Ethernet cable (supplied)
• IP address, subnet, gateway, and DNS information for installations not using DHCP
How to use this chapter
The following list shows the procedures for modifying the TCP/IP settings on the computer. The
procedure is slightly different depending on the operating system that you are using. Please
ensure you are using the correct steps for the operating system on your computer. Follow the
links below for instructions to configure your Ethernet connection on your operating system.
• TCP/IP Configuration for Windows 2000
• TCP/IP Configuration for Windows XP
• TCP/IP Configuration for Windows Vista
• TCP/IP Configuration for Windows 7
• TCP/IP Configuration for Windows 8
• TCP/IP Configuration for MacOS X